Shutdown and Cleanup
27
WARNING
Read warnings, page 4.
When you have finished spraying:
1 Drain remaining material into
bucket until most of texture
material is out of hopper.
2 Fill hopper with clean water. 3 Remove nozzle (L) from gun
and allow water to flow through
and out of gun. Flush until gun
is clean.
4 Open gun air valve (aa), forc-
ing air through nozzle to clear
out any remaining material.
When you have finished spraying:
1234
When you have finished spraying:
1234
WASTE
ti4290a
ti4301a
ti4009a
L
ti4000a
aa
To Next Page
Loading...
