Shutdown and Cleanup
29
9 Pour a couple gallons of
clean water to hopper.
10 Place end of material hose in
waste bucket.
11 Turn sprayer main power (A)
ON.
12 Circulate water through
sprayer until ball comes out of
hose.
13 Retrieve and clean ball with
clear water.
14 Finish cleaning all compo-
nents. A soft brush may be
used to help loosen any dried
on material from surface.
Be sure to keep air passages
in needle clean and free of
material.
Clean inside gun.
To improve working condition for
future use, after cleaning apply
a few drops of light oil to:
• air hose quick connect
• material hose connections
• air shutoff needle (model
248091)
• material needle
water
ti4301a
ti4653a
ti4010a
OIL
ti4652a
To Next Page
Loading...
