A
Amber MorganSep 12, 2025
What to do if the packing on my Graco Paint Sprayer is worn or dry?
- DDr. Alan WagnerSep 12, 2025
If the packing on your Graco Paint Sprayer is worn or dry, lubricate or replace it.
To Next PageTo Next PageWhat to do if the packing on my Graco Paint Sprayer is worn or dry?
If the packing on your Graco Paint Sprayer is worn or dry, lubricate or replace it.
Why is my Graco Paint Sprayer producing a thick, dimpled finish?
A thick, dimpled finish (resembling orange peel) from your Graco Paint Sprayer is caused by holding the gun too close to the surface. Hold the gun about 6-8 inches (150-200 mm) from the surface.
What to do if the needle on my Graco Sharpe Finex FX2000 feels sluggish?
If the needle on your Graco Paint Sprayer feels sluggish, you should clean and lubricate it.
What to do if my Graco Paint Sprayer's atomization air pressure is too high?
If the atomization air pressure is set too high on your Graco Paint Sprayer, reduce the air pressure.
What to do if my Graco Sharpe Finex FX2000 Paint Sprayer's fluid is too thick?
If the fluid you're using with your Graco Paint Sprayer is too thick for gravity feed, thin the material.
What to do if my Graco Paint Sprayer cup is empty?
If the cup of your Graco Paint Sprayer is empty, fill it.
What to do if my Graco Sharpe Finex FX2000 has worn fluid nozzle or needle?
If your Graco Paint Sprayer has a worn fluid nozzle or needle, replace it.
What to do if my Graco Paint Sprayer has dried material between the nozzle and gun body?
If there's dried material between the nozzle and gun body of your Graco Paint Sprayer, clean the nozzle and the front of the gun.
What to do if the fluid adjustment knob on my Graco Paint Sprayer is turned too far clockwise?
If the fluid adjustment knob on your Graco Paint Sprayer is turned too far clockwise, adjust the knob counterclockwise.
What to do if the packing nut on my Graco Paint Sprayer is too tight?
If the packing nut on your Graco Paint Sprayer is too tight, loosen it.
General| Material | Aluminum |
|---|---|
| Fluid Tip Size | 1.4 mm |
| Air Pressure | 29 PSI |
| Fluid Delivery | 0.38 GPM |
| Flow Rate | 0.38 GPM |
| Tip Size | 1.4 mm |
Flammable fumes in work area can ignite or explode. Prevent by ventilation, no ignition sources, grounding.
Misuse can cause death or serious injury. Follow safe operating, maintenance, and usage guidelines.
Fluid can splash and cause injury. Relieve pressure before servicing and check connections.
Toxic fluids/fumes can cause injury or death. Read MSDS, store properly, wear gloves.
