To Next PageTo Next Page
Need help?Do you have a question about the Grafik Eye 3100 and is the answer not in the manual?
General| Brand | Grafik Eye |
|---|---|
| Model | 3100 |
| Category | Control Unit |
| Language | English |
Identifies compatible load types for Control Units.
Details preparation steps for mounting the Control Unit.
Provides crucial notes for connecting line voltage and mains wires.
Crucial safety and installation guidelines for wiring.
Explains Class 2/PELV wiring requirements for Wallstations.
Illustrates the physical mounting procedure for the Control Unit.
Guides on how to test the installed Control Unit and lights.
Emphasizes critical wiring guidelines for Wallstations.
Lists various types of compatible Wallstation models.
Procedure for accessing and leaving the unit's setup mode.
Guide to setting the correct load type for each lighting zone.
Defines scenes as preset light levels and fade times.
Step-by-step guide to programming lighting scenes and fade times.
Method for making temporary light level adjustments without saving.
Procedure to adjust the lowest dimming level to prevent flicker.
Advanced settings for programming scenes 5 through 16.
Steps to configure a zone to remain unaffected during scene changes.
Guide to selecting different save options for scene settings.
Explains the purpose of system communication setup.
Conditions under which communication setup is not required.
Conditions when system communication setup is necessary.
Critical checks before setting up system communications.
Process for assigning unique system addresses to Control Units.
Procedure for configuring Wallstations to communicate with Control Units.
Method for establishing two-way communication between Control Units.
Explains the definition and requirements of PELV circuits.
Key considerations for proper wiring separation and cable types.
Wiring diagram and limits for small system configurations.
Additional wiring guidelines for small projects.
Wiring overview for larger system configurations.
Critical wiring notes for large projects.
Guidance on installing external power supplies for expanded systems.
Crucial guidelines for external power supply connections.
Spacing guidelines for mounting multiple units in wallboxes.
Requirements for mounting units within enclosures.
Steps for wiring Power Boosters and Interfaces.
Technical specifications for the GRX-TVI interface.
Instructions for mounting and wiring the GRX-TVI interface.
General wiring overview for GRX Interfaces.
Technical specifications for HP Dimming Modules.
Guidelines for selecting an appropriate mounting location.
Instructions for physically mounting HP Dimming Modules.
Information on handheld infrared remote controls.
Discusses potential IR interference issues and solutions.
Covers common problems, their causes, and remedies for the system.
