Graham Field LUMEX SELECT Series User Manual

LS300-INS-LAB-RevD19 20
Manufacturer’s declaration-electromagnetic immunity
The LS300 is intended for use in the electromagnetic environment (for home and professional
healthcare) specified below.
The customer or the user of the LS300 should assure that it is used in such an environment.
Immunity test IEC 60601
test level
Compliance level
Electromagnetic
environment-guidance
(for home and professional
healthcare environment)
Electrostatic
discharge(ESD)
IEC 61000-4-2
Contact:±8 kV
Air±2 kV,±4 kV,±8 kV,±15
kV
Contact:±8 kV
Air±2 kV,±4 kV,±8
kV,±15 kV
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be at
least 30%
Electrical fast
transient/burst
IEC 61000-4-4
+ 2kV for power supply
lines
+ 1kV for input/output
lines
+ 2kV for power supply
lines
Not applicable
Mains power quality should
be that of a typical home
healthcare environment.
Surge
IEC 61000-4-5
+ 0.5kV, +1kV line(s) to
line(s)
+ 0.5kV, +1kV,+ 2kV
line(s) to earth
+ 0.5kV, +1kV line(s) to
line(s)
Not applicable
Mains power quality should
be that of a typical home
healthcare environment.
Voltage Dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-4-11
Voltage dips:
0 % U
T; 0,5 cycle
0 % U
T; 1 cycle
70 % U
T; 25/30 cycles
Voltage interruptions:
0 % U
T; 250/300 cycle
Voltage dips:
0 % U
T; 0,5 cycle
0 % U
T; 1 cycle
70 % U
T; 30 cycles
Voltage interruptions:
0 % U
T; 300 cycle
Mains power quality should
be that of a typical home
healthcare environment. If
the user of the LS300
requires continued operation
during power mains
interruptions, it is
recommended that the
LS300 be powered from an
uninterruptible power supply .
Power frequency(50, 60
Hz) magnetic field
IEC 61000-4-8
30 A/m
50 Hz or 60 Hz
30 A/m
60 Hz
The LS300 power frequency
magnetic fields should be at
levels characteristic of a
typical location in a typical
home healthcare
environment.
NOTE UT is the a.c. mains voltage prior to application of the test level.
*DuringDIPinterference,thepumpwilloutage.Theaircellsconnectedwithpumpstill
haveairinsidewhichwon’taffecttheuseandfunctionofthesystem.
*DuringDIP,pumpwillshowabnormalbutwon’taffectessentialperformanceandno
needtoworrythebasicsafety. 

Graham Field LUMEX SELECT Series Specifications

General

Brand	Graham Field
Model	LUMEX SELECT Series
Category	Indoor Furnishing
Language	English

Summary

Introduction

Intended Use

Defines the system's purpose and target user age.

Contraindications for Use

Lists conditions where the system should not be used.

Symbol Definition

Explains symbols used in the manual and on the device.

Safety Precautions

Significance of Safety Statements

Explains the meaning of DANGER, WARNING, CAUTION, NOTICE, and INFO statements.

Electrical Safety

Specific DANGER warnings related to electrical hazards.

General Hazard Warnings

General WARNINGs for fire, electrical, and personal injury risks.

Features

Pump and Mattress System

Describes the overall system technology and function.

Pump Features

Lists key features of the pump unit.

Mattress Features

Lists key features of the mattress overlay.

Handling Procedures

Unpacking

Steps for safely removing the system from packaging.

Storage

Guidelines for storing the pump and mattress.

Waste Disposal

Information on environmentally responsible disposal of the product.

Setup

Mattress Installation

Instructions for placing and securing the mattress on the bed frame.

Pump Installation

Steps for connecting and positioning the pump unit.

Operating Instructions

Skin Care

Recommendations for maintaining patient skin health.

Incontinence / Drainage

Advice for managing incontinence with the system.

General Pump Operation

Explains the use of the pump's power, auto firm, and time buttons.

Static Function

How to set and use the static mode.

Alternate Function

How to set and use the alternating pressure modes.

Low Pressure Alarm

Explanation of the low pressure alarm and its muting.

Lockout Feature

How to enable and disable the control panel lockout feature.

CPR Deflation

Procedure for rapid deflation of the mattress.

Care and Maintenance

Cleaning and Disinfection Overview

General guidelines for cleaning and disinfection procedures.

Mattress and Cover Cleaning

Detailed instructions for cleaning the mattress and its cover.

Pump Cleaning and Disinfection

Specific instructions for cleaning the pump unit.

Inspection and System Check

Procedures to verify system functionality before patient use.

Replace Air Filter

Instructions for replacing the air filter in the pump.

Troubleshooting

Specifications

Mattress Overlay Specifications

Technical specifications for the mattress overlay.

Pump Specifications

Technical specifications for the pump unit.

Limited Warranty

Scope of Warranty

Outlines what the warranty covers and for how long.

Obtaining Warranty Service

How to contact GF for warranty claims and service.

Warranty Exclusions

Lists items/conditions not covered by the warranty.

Warranty Disclaimer

Legal disclaimer and limitations of GF's liability.

EMC Related Notification

Electromagnetic Emissions Declaration

Declares the device's electromagnetic emission compliance.

RF Separation Distances

Guidance on maintaining safe distances from RF devices.

Electromagnetic Immunity

Details immunity test levels and compliance for various disturbances.

RF Wireless Immunity Tests

Specifies immunity tests for RF wireless communications equipment.

Enclosure Port RF Immunity

Test specifications for enclosure port immunity to RF wireless communications equipment.