Gram Eco Plus U 70 - Defrost Water; Door Closing Mechanism; Power Failure

Do not use sharp or pointed objects to accelerate the defrosting process.
Defrost water
PLUS/TWIN/EURO cabinets
The product produces water during defrosting, which is led into a defrost water pipe going to the
rear bottom of the cabinet. The cabinet is mounted with a re-evaporation tray, with a heating
element underneath the cabinet as a standard. This heating element is operated in parallel with
the ongoing refrigeration cycle. In case this tray does overflow the heating element can be
connected to 100% line (main supply in the control box). This will however make the heater run
constantly. It is always advisable to connect the drain line to an external drain or an external drain
pump if possible. In order to do so the tray and the heating element must be disconnected and
should be removed.
MIDI cabinets
On Midi cabinets the re-evaporation tray including a heater operated by a level switch, is placed
inside the lower compartment on the right side. It is always advisable to connect the drain line to
an external drain or an external drain pump if possible. In order to do so the tray and the heating
element should be disconnected and removed.
IN GENERAL: It is recommended to clean the re-evaporation tray and corresponding
parts at least once a year, if used. Remember to disconnect the cabinet before
cleaning. Make sure the heating element has had time to cool, before performing the
cleaning of the tray.
Be careful not to damage the heating element and the water level switch (if fitted)
during cleaning.
Door closing mechanism
The door is equipped with a self-closing system. If the door is opened less than 90, it will self-
close. If the door is opened more than 90, it will stay open.
The door can be opened by using the pedal door opener (Not on Midi). This leaves both hands
free when placing foodstuff inside the cabinet.
In order to ensure proper self-closing of the door it is of great importance that the cabinet is
levelled correctly.
Power failure
In the event of a power failure, the control remembers the temperature setting and restarts the
product when power is restored.