Read the text below thoroughly before electrical connection.
The product is intended for connection to alternating current. The connection voltage (V)
and frequency (Hz) is shown on the name plate in the cabinet (see Fig. 8). Do only
connect the product to the power supply which is stated on the product name plate. Only
the supplied or similar cord is to be used.
Never use an extension cord for this appliance!
If a wall socket is placed further away than the length of the supplied power cord, contact
an electrician to establish a wall socket within the range of the supplied power cord.
If the product is defective, it should be examined by the company which has connected
the product to the remote system. As a minimum, servicing and troubleshooting must be
carried out by a skilled service technician knowing the installed controller and
experienced in servicing a CO
2
cabinet.
Fig. 5 Fig. 8
Always disconnect the power if interruptions in power supply occur, and when electrical parts are
removed/put on, and before cleaning and maintenance of the product.
Do not re-connect the cabinet to the power supply until all covers have been re-installed in order to make
sure that no rotating, hot or live parts can be accessed/touched.
The product may not be installed/used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The plug and wall
socket should then give correct earthing. In case of any doubt, contact an electrician.
Make sure the product is switched off at the socket or that the kettle plug is
disconnected (Fig.5), before service is performed on electrical parts. It is not
sufficient to switch off the product at the controller.
If service is to be carried out on electrical parts the main power supply of the
cabinet must be disconnect. This can be done by pulling the plug out of the
wall socket or by pulling the kettle plug on the rear or the left side of the main
control box (depending on model). It is not enough to turn off the power supply
on the 2-pole main switch, as there will still be power on the appliance inlet
inside the control box.
Type
REF
PO No
S/N
Input: V Hz W A
Defrost: W
Refrigera nt: g
Climate c lass:
Isolatio n class:
Foam pr opellant Cyclop entane
Permissible opera tion over-pressure:
Suction side: 10 ba r
Discharge side: 25 b ar
Gram Co mmercial A/S
Aage Gr ams Vej 1, 6500 Vojens
Denmar k CVR nr. 12 00 6 6 32
Type
REF
PO No
S/N
Input: V Hz W A
Defrost: W
Refrigera nt: g
Climate c lass:
Isolatio n class:
Foam pr opellant Cyclop entane
Permissible opera tion over-pressure:
Suction side: 10 ba r
Discharge side: 25 b ar
Gram Co mmercial A/S
Aage Gr ams Vej 1, 6500 Vojens
Denmar k CVR nr. 12 00 6 6 32
To Next Page
Loading...
