13
On range setup (on-ra)
Press the key for 3 seconds until the display shows the message
“range”, press again the key until you see “on-ra”. Press the to
access to the function and to select the desired option between 20% of
F.E and 100% of F.E. To confirm press the key .
Displays setup (d-dp)
Press the key for 3 seconds until the screen shows the message “range”,
press again the key until you see “d-dp”. Press the key to access and
press the key to select the desired option.
N= Only one display
Y= Two displays
Press the key to confirm and exit.
Counting pieces mode
Enter to “change units” and select the option “pcs”. Press the key and
then the indicator “pcs” will light on.
Sampling procedure:
Press the key , the message “count” will appear. Put the sample on the
weighing pan and press the key in order to introduce the sample’s value.
Press the key to increase the value of the digit and press the key to
move to the right. When the last digit flashes, press the key to finish the
sampling, now the display will show the number of pieces used as a sample.
To exit, enter again to “change units” and select the desired unit weight, the
To Next Page
Loading...
