Material No. 1 447 263
Removal, installation
1 Remove the seat cushion (Chap. 3.2).
2 Remove the bellows at the front, right
and left of the upper suspension
component and press down
(see Chapter 3.5).
3 Mark the installation location of the
linkage (1).
4 Unhook the linkage (1) from the lower
suspension component (4).
5 Unclip the linkage (1) on the holder (5)
of the housing seat level indicator (2)
and remove.
Installation instructions:
● Install the linkage (1) as marked.
● When mounting, ensure that the
upper end of the linkage (1) engages in
the longitudinal guide (arrow) of the
pointer (3).
6 Installation is carried out in reverse
order.
To Next Page
Loading...
