39
TRANSPORT
TRANSPORT WITH TRANSPALLET
WARNING!
The transport and handling activities described in this section must be performed by qualified
personnel with specific skills for such operations.
WARNING!
Refer to the "Technical data" section for the weight of the appliance.
The appliance is transported to the point closest to the installation lsite on a pallet by means of a transpallet.
Observe the minimum fork length specified in the section "TABLE OF DIMENSIONS AND WEIGHT FOR
TRANSPORT".
To handle the machine by transpallet, proceed as follows:
Step Action
1 Place the transpallet forks under the pallet to which the appliance is fastened.
2 Slowly lift by a few inches and check the grip stability.
3 Proceed slowly until near the place of installation and lower the load again.
Once at the site chosen for installation, proceed as follows:
Step Action
1 Unscrew the pallet fixing screws on the base of the appliance.
2 Gently slide the appliance off the pallet.
3 Manually push it to the point chosen for installation.
To Next Page
Loading...
Need help?
General
