80
WASHING MACHINE Series GWH / GWM / GWN
TROUBLESHOOTING
111 Wrong TT-TNC-TNS configuration
112 Faulty or disconnected imbalance micro switch
113 Drum left in neutral from programming to final spin
114 Odd or imbalanced load
115 Breakage of tie rods fixing weights
116 Noisy belt
117 Resistors and their fixings loose
118 Loose panels
119 Collision between cables/pipes with the moving part
120 24V utility (valves, contactors, coils) in cc or overload
121 A channel of the safety circuit does not work
122 Safety circuit actuated
123 Open door
124 Unlocked lock
125 Empty water recovery tanks
126 Sensors and their connection faulty
127 Detergent low level
128 Signal actuator failed feedback
129 The drum rotates when not required
130 Wrong motor model
131 Wrong inverter model
132 Overbraking
133 Faulty or badly adjusted proximity sensor
134 Power failure during cycle
135 Blocked pump and/or motor
136 Insufficient motor cooling
137 Jammed/stuck heating contactor
138 Open door
139 Another machine on the same line. Water is fed back from the drain
140 Porthole handle closing incorrect or not in correct position
141 Excessive foam
142 Excessive tightening of the lock fixing screws
REMEDIES
To Next Page
Loading...
Need help?
General
