Grandstream Networks GDS3710 - Configure Alarm In;Out on GDS3710; Alarm Schedule; Figure 13: Alarm Config Page Settings

P a g e | 16
GDS3710 Input/output Connection Guide
Configure Alarm In/Out on GDS3710
In order to configure the Alarm In/Out on the GDS3710, access the webGUI, after detecting the GDS3710
IP address using one of the methods previously mentioned, and log in as admin (the default user/pass for
admin log in is admin/admin).
Navigate under “Alarm Config”, this tab contains four sub sections as shown below.
Figure 13: Alarm Config Page Settings
Alarm Schedule
This page specifies the configuration of Alarm Schedule. Schedule must be in place before the alarm take
the related action.