To Next Page

To Previous Page

Encoding Rules:

Alphabet A – Z mapping to digit 1 – 26 respectively, no difference in lower or up case.

A B C D E F J H I G K L M N O P Q R S T U V W X Y Z

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Operation Steps:

1. When device is idle, input the special keypad combination with format: ***last_6_MAC**#

2. Device will reach restore mode after correct digits in Step 1) entered. The backlight of keypad will flash quickly to tell

operator the device is now in password reset/restore mode.

3. Operator will enter the correct decoded default password ending with # with format: default_password_code# via the

keypad within 60 seconds.

4. If wrong code combination entered, the GDS3705 will beep with error sound (three short beeps) then exit the password

reset mode, and the backlight will stop flashing.

5. If the correct default password decoded entered within 60 seconds, GDS3705 will play a long beep sound (advising

correct operation), the device will reboot itself automatically.

6. If keypad entry time out (not finish the input within 60 seconds), the device will exit this password reset mode

automatically and stop the backlight flashing.

7. After successful password reset, operator will then be able to log into the GDS3705 webUI with default password, all the

configuration inside the device will be the same and will NOT be changed.

For example:

Decoding the string into digits and write to paper before doing the operation:

Device with last 6 MAC address: 33DDDD

Decoding the last 6 MAC to digits would be: 334444

Default password is: xwpxz6AA

Decoding the default password to digits would be: 2423162426611

1. Enter ***334444**# via keypad, get into the password reset mode, the keypad backlight will flash quickly.

2. Within 60 seconds, enter 2423162426611#, the device will play one long beep then reboot itself.

3. Wait the device finishing boot up, log in the webUI using the default password, xwpxz6AA

CHANGE LOG

This section documents significant changes from previous versions of the user manual for GDS370x. Only major new features

or major document updates are listed here. Minor updates for corrections or editing are not documented here.

Notes

1. MAC address of the GDS370x (check the sticker at back of the device)

2. Default password of the GDS370x (check the sticker at the back of the device)

3. Correct decoding the last 6 MAC address into digits (refer to encoding rule)

4. Correct decoding the default password into digits (refer to encoding rule)

5. Finish keypad input within 1 minute

Grandstream Networks GDS3712 User Manual

Other manuals for Grandstream Networks GDS3712