Added support for DHCP Option 42. [Allow DHCP Option 42 to override NTP server]
Added support for Voice Frame Per TX at audio settings. [Table 15: SIP Account Basic & Advanced Settings]
Added support of separated webUI credentials for GDSManager. [GDSManager Configuration Password]
Added support for G.729 audio codec. [Table 15: SIP Account Basic & Advanced Settings]
Added ability to enable multiple audio codecs simultaneously and specify priority of codecs. [Table 15: SIP Account Basic
& Advanced Settings]
Added support for randomize firmware upgrade and provisioning. [Upgrade]
Firmware Version 1.0.0.41
Added support for second door control via Alarm Output 1. [Using Alarm Out (COM 1) to Control a Second Door]
Added support for “Normal Open” or “Normal Close” setting when Alarm Out1 is set to Open Door. [ALMOUT1 Status]
Added option to specify digital input to be normal Open or normal Close. [Digit Input 1 Status]
Added support for using Digit Only as Private PIN. [Local PIN Type]
Added support for System Health Alerts via Email. [System Health Alert]
Added option to upload custom doorbell ringtone. [Enable Custom Doorbell Ringtone]
Added option to disable WEB/SSH access. [Access Settings]
Added option for calling out automatically without pressing #. [No Key Input Timeout(s)]
Added option to disable SIP dialing from GDS keypad. [Disable Keypad SIP Number Dialing]
Added option to set Schedule for “Local PIN to Open Door”. [Local PIN to Open Door Schedule]
Added option to customize DTMF Payload. [DTMF Payload Type]
Added RTCP/RTCP-XR for SIP Call. [Technical Specifications] [Enable RTCP]
Added Boot version information into System status. [System Info]
Enhanced security by only allowing numbers existing under “White List” to open the door remotely when call is initiated
from GDS3705. [Remote PIN to Open the Door]
Added option to synchronize Keep Door Open from GDSManager version 1.0.1.1 or later. [Central Mode]
Firmware Version 1.0.0.37
Added event log showing the users (Username) opening door via private PIN [Event Log]
Added SIP NOTIFY to factory reset [Allow Reset Via SIP NOTIFY] [Restore to Factory Default Via SIP NOTIFY]
Added option to disable outbound proxy route header [Outbound Proxy Mode]
Added option to verify received SIP Message [Validate Incoming Messages]
Firmware Version 1.0.0.36
Added support for special character “@” in the SIP User ID. [SIP User ID]
Added SIP password hided and not visible in the Web UI. [Password]
Extended VLAN range from 0-4094. [Layer 2 QoS 802.1Q/VLAN Tag]
Added ability to configure device with custom certificate signed by custom CA certificate [Certificates]
Added option to display device temperature in Fahrenheit. [System Temperature]
Firmware Version 1.0.0.35
Added option to assign a schedule to the doorbell. [Press Doorbell Schedule]
Added option to set the maximum number of digits dialed. [Maximum Number of Dialed Digits]
Added support for Parallel Hunting when doorbell pressed. [Door Bell Call Mode]
Added firmware check status button. [Firmware Status]
Added Account section. [Account]
Enhanced Event Notification Template Variables. [Event Notification]
To Next Page
Loading...
Need help?
General
