GRP260x Administration Guide
Version 1.0.1.18
Controls whether the Privacy header will present in the SIP INVITE message
or not, whether the header contains the caller info.
• Default: The Privacy Header will show in INVITE only when “Huawei
IMS” special feature is on.
• Yes: The Privacy Header will always show in INVITE.
• No: The Privacy Header will not show in INVITE.
The default setting is “default”.
Use P-Preferred-
Identity Header
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message.
• Default: The P-Preferred-Identity Header will show in INVITE unless
“Huawei IMS” special feature is on.
• Yes: The P-Preferred-Identity Header will always show in INVITE.
• No: The P-Preferred-Identity Header will not show in INVITE.
The default setting is “default”.
Use X-Grandstream-
PBX Header
Enables / disables the use of X-Grandstream-PBX header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is “Yes”.
Use P-Access-
Network-Info Header
Enables / disables the use of P-Access-Network-Info header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is “Yes”.
Use P-Emergency-Info
Header
Enables / disables the use of P-Emergency-Info header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is “Yes”.
• If Yes for REGISTER only, the sip message for register or unregister
will contains MAC address in the header, and all the outgoing SIP
messages except REGISTER message will attach the MAC address to
the User-Agent header.
• If Yes to all SIP, the sip message for register or unregister will contains
MAC address in the header, and all the outgoing SIP message including
REGISTER will attach the MAC address to the User-Agent header.
• If No, neither will the MAC header be included in the register or
unregister message nor the MAC address be attached to the User-Agent
header for any outgoing SIP message.
The default setting is “No”.