Grandstream Networks GXP1400 User Manual

FIRMWARE VERSION 1.0.4.23 GXP1400/GXP1405 USER MANUAL Page 32 of 60
your VoIP service provider (ITSP).
Secondary SIP Server
The URL or IP address, and port of the SIP server. This will be used
when the primary SIP server fails.
Outbound Proxy
IP address or Domain name of the Primary Outbound Proxy, Media
Gateway, or Session Border Controller. It's used by the phone for
Firewall or NAT penetration in different network environments. If a
symmetric NAT is det
ected, STUN will not work and ONLY an Outbound
Proxy can provide a solution.
SIP User ID
User account information, provided by your VoIP service provider
(ITSP). It's usually in the form of digits similar to phone number or
actually a phone number.
Authenticate ID
SIP service subscriber's Authenticate ID used for authentication. It can
be identical to or different from the SIP User ID.
Authenticate Password
The account password required for the phone to authenticate with the
ITSP (SIP) server before the
account can be registered. After it is saved,
this will appear as hidden for security purpose.
Name
The SIP server subscriber's name (optional) that will be used for Caller
ID display.
DNS Mode
This parameter controls how the Search Appliance looks up IP
addresses for hostnames. There are four
modes: A Record, SRV,
NATPTR/SRV, Use Configured IP
. The default setting is "A Record". If
the user wishes to locate the server by DNS SRV, the user may select
"SRV" or "NATPTR/SRV". If "Use Configured IP" is select
ed, please fill
in the three fields below:
• Primary IP
: The primary IP address where the phone sends DNS
query to;
• Backup IP 1;
• Backup IP 2.
TEL URI
If the phone has an assigned PSTN telephone number, this field should
be set to "User=Phone". Then a "User=
Phone" parameter will be
attached to the Request-
Line and "TO" header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead
of "SIP:" in the SIP request. The default setting is "Disable".
SIP Registration
Selects
whether or not the phone will send SIP Register messages to
the proxy/server. The default setting is "Yes".
Unregister On Reboot
If set to "Yes", the SIP user's registration information will be cleared
when the phone reboots. The SIP Contact header will contain "*" to
notify the server to unbind the connection. The default setting is "No".

Grandstream Networks GXP1400 Specifications

General

Brand	Grandstream Networks
Model	GXP1400
Category	IP Phone
Language	English