P a g e | 41
GXP16XX User Guide
Version 1.0.7.18
even when # could be used as SEND in normal phone calls.
For 3-ways and 4-ways conference, the host hangs up the phone will end the conference. If users want
to keep the rest 2 parties stay in conference after the host hangs up, go to Web GUIAccount Call
SettingsTransfer on conference Hangup, check "Yes" and save the change.
Voicemail
A blinking red LED indicator on the top right corner of the GXP1610/GXP1615/GXP1620/GXP1625/
GXP1628/GXP1630 indicates a message is waiting. Go to Web GUIAccount General Settings to
configure Voice Mail UserID.
To retrieve the voicemail:
1. Press the hard key to dial into the voicemail box.
2. Select the account and confirm to access the dial-up interface, make operations according to the
voice prompt.
3. Enter the account and password which is configured on SIP PBX.
The steps above are for the situation that both accounts are configured, if configured only one account,
there is no need for users to select account but go to the dial-up interface directly.
For each account, the Voicemail User ID can be set up under Web GUIAccount XGeneral Settings:
"Voice Mail UserID". This is the number that will be dialed out to access voicemail message when tapping
on the account in Voice Mail screen.
Shared Call Appearance (SCA)
The GXP1610 / GXP1615 / GXP1620 / GXP1625 / GXP1628 / GXP1630 phone supports shared call
appearance by Broadsoft standard. This feature allows members of the SCA group to shared SIP lines and
provides status monitoring (idle, active, progressing, hold) of the shared line. When there is an incoming
call designated for the SCA group, all of the members of the group will be notified of an incoming call and
will be able to answer the call from the phone with the SCA extension registered.
All the users that belong to the same SCA group will be notified by visual indicator when a user seizes the
line and places an outgoing call, and all the users of this group will not be able to seize the line until the line
goes back to an idle state or when the call is placed on hold (with the exception of when multiple call
appearances are enabled on the server side).
In the middle of the conversation, there are two types of hold: Public Hold and Private Hold. When a member
of the group places the call on public hold, the other users of the SCA group will be notified of this by the
red-flashing button and they will be able to resume the call from their phone by pressing the line button.
However, if this call is placed on private-hold, no other member of the SCA group will be able to resume
To Next Page
Loading...
Need help?
General
