802.1x mode: This option allows the user to enable/disable 802.1x mode on the phone. The default setting is disabled. To
enable 802.1x mode, select from the available modes: EAP-MD5, EAP-TLS and EAP-PEAP
Wi-Fi
Tap on “Wi-Fi” to turn on/off Wi-Fi connection. By default, it’s turned off.
Tap on “Wi-Fi Band” to select the band, three options are available: 2.4G & 5G, 2.4G or 5G
Select the Wi-Fi SSID from the available list then enter the password to get connected, there are also options for a proxy
or assigning a static IP.
In case the Wi-Fi SSID is not showing up on the Available WLAN List or it’s hidden, then scroll down to the bottom of
the page and tap on Add network, then enter the name of the SSID and the password to connect.
VPN
Enable / Disable OpenVPN for Android.
Refer to the Network Settings/OpenVPN Settings section for advanced configuration on the web interface.
General Network Settings
LLDP
Turn on/off LLDP on the GXV34x0. If turned on, the phone will be able to discover the LAN polices as set up in the switch side
to obtain network settings such as VLAN tag, Layer 2 QoS 802.1p priority and Layer 3 QoS in a plug-and-play manner.
LLDP TX Interval
Specifies the time interval, in seconds, between successive LLDP-MED transmission cycles
Layer 3 SIP QoS
This field defines the layer 3 QoS parameter for SIP packets.
This is the value used for IP Precedence, Diff-Serv or MPLS. The Default value is 26.
Layer 3 Audio QoS
This field defines the layer 3 QoS parameter for audio packets. This is the value used for IP Precedence, Diff-Serv or MPLS. The
Default value is 46.
Layer 3 Video QoS
This field defines the layer 3 QoS parameter for video packets. This is the value used for IP Precedence, Diff-Serv or MPLS. The
Default value is 34.
Applied to the Second Layer of Data QoS 802.1Q/VLAN tag (Ethernet)
This field contains the value used for layer 2 VLAN tagging for the Ethernet network.
The Default value is 0.
Applied to the Second Layer of Data QoS 802.1p Priority (Ethernet)
This assigns the priority value of the Layer 2 QoS packets on the Ethernet Network.
The Default value is 0.
Proxy Settings
To Next Page
Loading...
Need help?
General
