Grandstream Networks GXV3480 Manual

IP Mode
Selects the Internet protocol to use. When both IPv4 and IPv6 are enabled, phone will attempt to use
the preferred protocol first and switches to the other protocol if there are any issues.
Different
Networks for
Data and VoIP
Calls
Configures whether to set up different networks for the phone data and the call. If set to “Yes”, you
need to configure the data network and VoIP network respectively.
IPV4
IPv4 Address
Type
Configures the appropriate network settings on the phone. Users could select from “DHCP”, “Static IP”
or “PPPoE”(Point-to-point Protocol over Ethernet).
By default, it is set to “DHCP”.
DHCP VLAN
Override
Selects the DHCP Option VLAN mode. When set to “DHCP Option 132 and DHCP option 133”, the
phone will get DHCP option 132 and 133 as VLAN ID and VLAN priority. When set to “Encapsulated in
DHCP Option 43”, the phone will get values from Option 43 which encapsulate VLAN ID and VLAN
priority.
Note: Please make sure the “Allow DHCP Option 43 and Option 66 to Override Server” setting under
maintenance
󰒇 upgrade is checked. The default setting is ” Encapsulated in DHCP Option 43 “.
DHCP Host name
(Option 12)
Sets the name of the client in the DHCP request. It is optional but may be required by some Internet
Service Providers.
Vendor Class ID
(Option 60)
Configures the vendor class ID header in the DHCP request.
The default setting is Grandstream GXV3480.
IP Address Defines the phone’s static IP address if the static IP is used.
Subnet Mask
Determines the network’s subnet mask if the static IP is used.
Default Gateway Defines the network’s gateway address if the static IP is used.
DNS Server 1 Configures the primary DNS IP address if the static IP is used.
DNS Server 2
Configures the secondary DNS IP address if the static IP is used.
PPPoE Account ID Configures the PPPoE account ID if the PPPoE is used.
PPPoE Password
Sets the PPPoE password if the PPPoE is used.
Layer 2 QoS
802.1Q/VLAN Tag
(Ethernet) for
Data
Assigns the VLAN Tag of the Layer 2 QoS packets for Ethernet.
The Default value is 0
Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied
for Data.
Layer 2 QoS
802.1p Priority
Value (Ethernet)
for Data
Assigns the priority value of the Layer 2 QoS packets for Ethernet.
The Default value is 0.
Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied
for Data.
IPV6
IPv6 Address
Type
Configures the appropriate network settings on the phone.
Users could select from “Auto-configured” or “Statically configured”.
Enable IPv6
Privacy Address
Configures whether to enable IPv6 privacy address. If enabled, the device will carry multiple IPv6
addresses. Note: This may cause problems with some servers such as BroadSoft and result in account
registration failure (invalid or no response).
Static IPv6
Address
The static IPv6 address when static IPv6 is used.
IPv6 Static
Gateway
The static gateway when static IPv6 is used.

Grandstream Networks GXV3480 Specifications

General

Brand	Grandstream Networks
Model	GXV3480
Category	Conference System
Language	English