Need help?Do you have a question about the GRAPHTEC CE7000-130 and is the answer not in the manual?
Advises on safe handling of sharp cutter blades.
Provides precautions for using cutter plungers and their blades.
FCC statement regarding radio frequency interference.
Explains how to establish a connection between the plotter and a computer.
Details the nomenclature, structure, and blade length adjustment of cutter plungers.
Provides step-by-step instructions for loading various types of media.
Guides on aligning push rollers for proper media feeding.
Details how to connect the plotter to a power source and turn it on.
Explains the functions of the control panel's keys and display.
Guides on setting tool conditions like speed, force, and acceleration.
Details how to perform test cuts to optimize settings.
Introduces the ARMS system for registration mark detection.
Provides detailed steps for setting up and adjusting the ARMS system.
Details the step-by-step procedure for manual position adjustment.
Explains tangential mode for cutting corners precisely.
Guides on setting initial blade position to prevent damage.
Explains setting offset force for blade alignment.
Details automatic media feeding upon receiving cut data.
Explains automatic media feeding when the plotter is powered on.
Explains how to set up USB, LAN, and RS-232C interfaces.
Guides on setting up network (LAN) interface including DHCP.
Sets the command type (GP-GL, HP-GL, or AUTO) for plotter communication.
Explains how to link and transfer data using USB memory.
Describes how to print and cut using bar codes for data identification.
Provides instructions for routine cleaning and care of the plotter.
Guides on how to safely replace the cutter blade.
Lists common problems, their causes, and solutions.
Guides on performing a self-diagnostic test of the plotter's components.
Lists the technical specifications for different CE7000 models.
To Next Page
General