C-4
Chapter 5: ARMS (Advanced Registration Mark Sensing System)
5.1 Outline of ARMS ....................................................5-2
Shape (Pattern) of the Registration Mark and Origin Point ............................5-3
Scan range necessary to detect the registration mark ...............................5-4
Positioning of the media and the registration mark ..................................5-6
Cutting area when adjusting the regisitaration mark .................................5-6
Automatic detection of registration mark position ...................................5 -7
Media that registration mark cannot be detected ...................................5 -7
5.2 Setting and Adjustment of ARMS ......................................5-8
Set the MARK SCAN Mode ...................................................5-8
Checking the recommended setting of registration mark ............................5 -10
Check the lines of registration mark ............................................5 -12
Test the registration mark sensor ..............................................5 -14
Adjusting for the registration mark scan position ...................................5 -16
Adjust after plotting the adjustment registration mark ..............................5 -16
Detect the registration mark for adjustment on the media and enter the value ............5-20
Setting the registration mark automatic detection ..................................5-23
Setting speed of the registration mark scan ......................................5-25
Chapter 6: Manual Position Adjust
6.1 Outline of Manual Position Adjust .....................................6-2
Setting mark scan mode and number of adjustment marks ...........................6-2
Adjust with 2POINTS .........................................................6-2
Adjust with 3POINTS .........................................................6-3
Adjust with 4POINTS .........................................................6-3
6.2 Manual Position Adjust ..............................................6-4
Chapter 7: Setting Regarding Cutting Quality
7.1 Cutting the Corner of Thick Media Sharp ...............................7-2
Outline of tangential mode .....................................................7-2
Setting the tangential mode ....................................................7-3
Setting the length of overcut ...................................................7-4
Setting of the Initial Down Force ................................................7-6
7.2 Setting the Step Pass ...............................................7-8
7.3 Setting the Offset Angle ............................................ 7-10
7.4 Setting the Distance Adjust ......................................... 7-12
7.5 Setting Cut Line Pattern ............................................ 7-15
7.6 Setting Initial Blade Control Position Adjust ........................... 7-19
7.7 Setting the OFFSET FORCE .........................................7-21
7.8 Setting Adjustment Between the Tools ................................7-22
In the case of Tool 1 - Tool 3 .................................................7-22
To Next Page
Loading...
