CE7000-130AP SETUP MANUAL
This manual provides the setup procedure.
For details on each function, refer to the instruction manual
(PDF) in the supplied CD.
Checking the Accessories
Please check that all the accessories are complete.
If you find any accessories missing, please contact the
distributor where you purchased or our customer center
immediately.
Accessories
* In addition, various information may be attached.
* Accessories may vary depending on the sales area.
* For details, please contact the distributor where you
purchased.
Dedicated accessories
A stand (with a basket) is supplied.
Installing driver/software
The latest driver / software version and installation
instructions are available at:
http://www.graphteccorp.com/support/index.html
Please download it if necessary.
•
Windows driver (Do not connect the computer to the cutting
plotter before installing.)
CD
(Various software/User's Manual (pdf))
1 pc.
SETUP MANUAL, TO ENSURE SAFE
AND CORRECT USE,
Cutter Blade Manual 1 of each
Cutter plunger (PHP33-CB09N-HS) 1 pc. Cutter blades (CB09UB (1P)) 1 pc.
Oil-based ballpoint pen plunger
(PHP34-BALL) 1 set
Cutter blade adjustment magnifier
(PM-CT-001) 1 pc.
Oil-based ballpoint pen
(KB700-BK-1P) 1 pc.
Power cable 1 pc. USB cable 1 pc.
Connecting to the Power
Make sure that the power switch is off ( side), and make a
connection between the power connector of the cutting
plotter and the AC outlet of specified voltage using the
supplied power cable.
Initial setup screen
The initial setup screen is displayed only when the power is
first turned on. Then select "DISPLAY LANGUAGE" and
"LENGTH UNIT". When the power switch is turned on
(I side), a message is displayed after displaying the version.
Select a language (English) and press the [ENTER] key.
Select the length unit and press the [ENTER] key.
It will return to default screen.
To Next Page
Need help?
General
