Even if the media is thinner than the extended blade length, its thickness, strength
and the hardness of the fibers may cause it not to be cut through completely. Please
refer to “Media is not cut properly” on page 27 of this guide and to the Craft ROBO
User’s Manual for the adjustment procedure. If the media still cannot be cut properly,
use Graphtec media.
When using thin media or media without a protective liner, the media is cut right
through and the cutting mat and blade may be damaged. Always affix such media to
the carrier sheet before cutting it.
The cutter blade has a certain life expectancy. If the cutting results deteriorate over
time, please purchase a new blade.
If copy paper is used as is, the paper will get caught up in the Craft ROBO and cause
malfunctions. Avoid using copy paper wherever possible. If you have to use it, cut off
the top corners as shown in the figure on the right. Please note, however, that the use
of copy paper may void the warranty.
Copy paper
The dimensions of the cut-off
sections are for reference only.
Please try different dimensions yourself.
Sections cut off
10mm
3mm
Graphtec only guarantees the cutting results for media supplied by Graphtec and cut under suitable conditions.
Please read all the following precautions carefully if you plan to use non-Graphtec media.
25
Usage Precautions for Media Used for Cutting
Media Type Precautions
Precautions on Using Thin Media, and Media without a Protective Liner
Cutter Blade Precautions
Precautions on Using Copy Paper
Usage Precautions for
Media Used for Cutting
4
To Next Page
Loading...
