6
Do not use or store the Craft ROBO in
a location exposed to direct sunlight
or the direct draft of an air conditioner
or heater.
• Such location may impair the
performance of the Craft ROBO.
Do not place any receptacle containing
water or other fluid on top of the Craft
ROBO.
• Fluid falling inside the Craft ROBO
may cause electrical shock or a fire
hazard due to current leakage.
Do not use the Craft ROBO in an
excessively dusty or humid location.
• Such location may impair the
performance of the Craft ROBO.
Do not use the Craft ROBO in a
location subject to excessive
mechanical vibration or electrical
noise.
• Such location may impair the
performance of the Craft ROBO.
When disconnecting the power cord or
an interface cable, do not pull on the
cord/cable.
• Such action will damage the cord/cable,
resulting in a fire hazard or electrical
shock. Be sure to hold the power cord’s
plug or the interface cable’s connector.
If water or foreign matter enters inside
the Craft ROBO, do not continue
using it. Turn off its power and unplug
its power cord from the electrical socket.
• Use of the Craft ROBO in such status
may result in electrical shock or a fire
hazard due to current leakage.
• Contact your sales representative or
nearest Graphtec vendor to request
repair.
Prohibited
Prohibited
Prohibited
Prohibited
Avoid water
Beware of electrical shock
Unplug the power
cord from the socket
CAUTION
Safety Precautions
To Ensure Safe and Correct Use
1
To Next Page
Loading...
