Click the [OK] button to start cutting.
Do not touch the Craft ROBO during the cutting
operation.
When cutting has been completed, remove the
sheet. Turn the feed knob to remove it.
44
Perform Cutting
1
Perform cutting
2
Finished!
[OK] button
9
Click
Click the [Cut...] button. The registration marks are
read automatically. Do not touch the printed sheet
during the reading operation, as this will affect the
accuracy.
3
Perform Auto Registration
Mark Reading
HINT
If a “Registration Mark Reading Failure”
error message is displayed, please refer
to the Craft ROBO User’s Manual
(CD-ROM).
33
Make preparations for cutting
Let’s try out the Craft ROBO
2
The pop-up card is complete when you assemble it.
To Next Page
Loading...
