Measuring Procedure
A basic information on the recording process:
Preparations -> Setup -> Record data -> Replay Data.
Example: voltage and temperature measurements.
Purpose : To measure voltage and temperature of the target objects
Temperature thermocouple : T type Thermocouple, 100
ºC
Voltage range : 1V
Sampling interval : 1 sec
Data save destination : Internal memory (SD1)
1. Connect wire to CH 1 terminal (Voltage).
2. Connect Thermocouple to CH 2 terminal (Temperature).
3. Connect the AC power supply.
4. Turn the power supply on.
1. Preparations : Hardware set up for Data Recording
10
Digital display area
Quick settings
Alarm display area
Pen display
File name display area
Scale lower limit
Waveform display area
Scale upper limit
Recording bar
12.
13.
14.
15.
16.
17.
18.
19.
20.
1
2
4
Screw tightly!
3
Measurement
object
Start side
Rriisg
tignegr
Falling
tignegr
Within
the range
Outside
the range
Alarm rangeTrigger position
Stop side
: Displays the input values for each channel. The and keys can be used
to select the active channel (enlarged display). The selected active channel
is displayed at the very top of the waveform display.
: Displays items that can be easily set. The and keys can be used to
activate a Quick settings item, and the and keys to change the values.
: Displays the status of the alarm output. (Red = alarm generated, white =
alarm not generated)
: Displays the signal positions, trigger
positions, and alarm ranges for each
channel. (see right figure)
: Displays the recorded file name during the
recording operation.
When data is being replayed, the display
position and cursor information are
displayed here.
: Displays the lower limit of the scale of the currently active channel.
: The input signal waveforms are displayed here.
: Displays the upper limit of the scale of the currently active channel.
: Indicates the remaining capacity of the recording medium during data
record.
When data is being replayed, the display position and cursor information are
displayed here.
To Next Page
Loading...
