21
Installation Guide
System Requirements
The following conditions are required to install a software.
OS : Windows 10 (32Bit/64Bit)
Windows 8.1 (32Bit/64Bit)
Windows 8 (32Bit/64Bit)
Windows 7 (32Bit/64Bit)
* Starter Edition are not supported.
Windows Vista (32Bit/64Bit)
* The OSs which OS maker support has been completed are not supported.
CPU : Pentium4 1.7GHz or higher
Memory : 256MB or more (512MB or more recommended)
HDD : 200MB (1GB recommended) additional space required for installing the application
software
Display : Resolution 1024 x 768 or higher, 65535 colors or above
(16 Bit or higher)
Others : CD-ROM drive (for installation from a CD) and USB port are necessary.
To Install the USB Driver
To connect GL240 to a PC with the USB interface. PC must have USB driver
installed.
A USB driver and the USB driver installation manual are stored on the supplied
CD-ROM. Install the USB driver according to this manual.
(The manual location: D:\USB Driver\English\GL-USB-UM152.PDF)
Note: D: drive name of CD-ROM. The letter of CD-ROM drive vary it with the CD-ROM drive of your PC.
Note: Refer to Graphtec website for latest version of the USB driver.
To Install GL240 Application Software
Follow the steps below for installation of application software for GL240.
1. Insert the accompanying midi LOGGER GL240 CD-ROM in the PC's CD drive.
2. Select [Start] > [Run] to open the [Run] window.
3. In the [Open] field, type in "D:\GL100_240_840-APS\Setup_English.exe" and
push [OK].
The installer starts.
4. Follow all directions displayed by the installer to continue.
Note: D: drive name of CD-ROM. The letter of CD-ROM drive vary it with the CD-ROM drive of your PC.
Note: Refer to Graphtec website for latest version of the application software.
Installing the GL240 application software.
To Next Page
Loading...
