2. Setup : Menu Operation
11
Select the setting for only the channels being recorded. Make sure to turn off
unused channels. It is unnecessary to change all settings from factory default.
Key Pointers
Basic Setup Menu Operation
•
Examples of selection menu operations (AMP screen)
(Note: Select "DC" for voltage measurement, and "TEMP" for temperature measurement.)
The , [ENTER], and [QUIT] keys are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green.
Use the keys to move the cursor. When the [ENTER] key is pushed at the cursor
position, a selection menu or a box entering value for other option is displayed.
If you push the [QUIT] key, the screen closes and for the option settings are canceled.
1. Use the keys to move
the cursor to the Input
parameter of CH 1 and then
push the [ENTER] key.
2. A selection menu is displayed
when the [ENTER] key is
pushed. Use the and keys
to select "TEMP."
3. Pushs the [ENTER] key to
confirm your selection.
1. Push the [MENU] key to display the setup menu screen.
3. Select "Off" for all the other channels.
2. Set Input to "DC" and Range to "1V" for CH1,
and set Input to "TEMP" and Sensor to "TC-T" for CH2.
(1) Move the cursor to CH1 "Input" and select "DC" and then move to
"Range" and select "1V".
(1) Using the procedure described above, select "Off" for CH 3 to CH 10.
(2) In the same way, move the cursor to CH2 "Sensor" and select "TC-T".
To Next Page
Loading...
