(4) Move the cursor to the "Level" parameter next to the "Mode" parameter
and then push the [ENTER] key.
(5) The input box shown in the following screen is displayed. Select "20".
Use the and keys to move to the cursor to the second digit from the
right, and the and keys to change the value. Push the [ENTER]
key.
(7) The screen returns to the TRIG menu screen. Push the [QUIT] key to
return the GL240 to the Free Running mode.
(8) Push the [START/STOP] key to start data record.
If the trigger condition has not been satisfied, the GL240 goes into the
"Armed" status as shown on the following screen.
(6) When the screen changes to the following screen, move the cursor to the
button and then push the [ENTER] key.
When the trigger condition is satisfied, the recording starts.
Numerical value input box
Lower and upper limit for setting.
Waveform area for confirmation
•Use the and keys to change the
values.
•Use the and keys to move the
digit.
•Use the [ENTER] key to enter the
value.
•Use the [QUIT] key to cancel the
setting.
17
To Next Page
Loading...
