7
Push the [MENU] key to open a setup menu. As you push the [MENU] key the
setup screen tabs change in the sequence shown below.
3. MENU
Push the [QUIT] key to cancel the settings and return to the default status.
If GL240 is in a Remote (Key Lock) status and is run by a computer via a USB or
WLAN interface, push the key to return to a normal operating status. (Local).
4. QUIT (LOCAL)
Direction keys are used to select menu setup items, to make span settings in the
digital display area, or to move the cursors during a data replay operation.
5. Keys (DIRECTION KEYS)
Push the [ENTER] key to submit the setting and to confirm your settings.
6. ENTER
Fast forward and rewind keys are used to move the cursor at high speed during
replay or change the operation mode in the file box. Hold down both keys
simultaneously for at least two seconds to lock the key bottons. (Orange key at the
top right of window indicates locked status).
To cancel key lock status, push both key again for at least two seconds.
* Pushing these keys simultaneously with the key + ENTER + key enables password protection
for the key lock operation.
7. Keys (KEY LOCK)
[Menu] Sequence
•
AMP Settings
Set the input, range, filter , scaling, and other channel based
settings.
•
Record Settings
Set sampling interval, data record destination, and calculations
during data record.
•
Trigger Settings
Set the specify recording start and stop conditions, and alarm
conditions.
•
Interface Settings
Set the USB ID.
•
Wireless LAN setting
(
displayed when B-568 option is installed
)
Set the connection to the wireless LAN after the wireless unit is
installed.
•
Other Settings
Set the screen brightness, background color, language and etc.
AMP
DAT
(
DATA
)
TRG
(
TRIG
)
I/F
LAN
OTH
(
OTHR
)
To Next Page
Loading...
