GRAPHTEC Yamato GL240 - Page 121

3-79
CHAPTER 3 Settings and Measurement
(10) Data replay menu
Select the data you want to replay from the “Data replay source” by pressing the [REVIEW] key and replay
the captured data.
<Select replay data source>
Select items Description
File Specify the le in the capture destination (save destination).
For CSV-formatted data, only the data captured by this GL240 can be replayed.
<When using the replay data and cursor B><When using the replay data and cursor A>
Cursor A Cursor B
Data replay menus are displayed by pressing the [MENU] key during replay.
Setting Selections available
Cursor
Position
Move to First Data Press right key to execute.
Move to Last Data Press right key to execute.
Move to Center Press right key to execute.
Move to
Selected Position
Method: Position, Time
[Position] Position 0 to end of data
For example, if the sampling interval is 100 ms, capture
destination is the built-in RAM, and the number of capture
points is 10000, settings up to 999.9ms are available.
[Time] Date Date from the start to end of the data
Time Time from the start to end of the data
Cursor Synch Off, On
Data search CH CH1 to 10, Logic, Pulse, Alarm
* Logic and Pulse are displayed only if the Logic Pulse
function is On in the AMP settings.
[CH1 to CH10]•WL CH1-10 , WL1-8
[Logic] Logic1-8
[Pulse] Pulse1-8
[Alarm] Alarm1- 4, WL1
Mode [CH1 to CH10]•WL
↑
H,
↓
L
[Logic]
↑
H,
↓
L
[Pulse]
↑
H,
↓
L
[Alarm] Both,
↑
H,
↓
L
Level [CH1 to CH10]•WL Set numeric value
[Pulse] Set numeric value
Find Next Press right key to execute.
Find Previous Press right key to execute.
Statistical
calculation
between cursors
Function Off, Average, Max, Min, Peak, RMS
Execute Press right key to execute.