25
Kaleido-MX (3RU)
Hardware Description & Installation Manual
If the Status LED is steady red (not blinking), use the Densité frame control panel to review
card status information (see
Local Control Panel Menu Structure, on page 27). If the card
status menu reports that an update is in progress, then you know that you should not
interrupt this process (by reseating the card, for example).
Output card power LED
Monitors the status of the power supplies on board the Kaleido-MX card.
Output card heartbeat LED
Monitors the status of the system firmware.
Memory card access LED
Monitors read/write operations to the SD memory card.
ETH communication LED
This LED is always OFF, and currently not relevant.
CPU 0 LED (not used)
This LED is always orange, and currently not relevant.
CPU 1 LED
Monitors the status of the firmware during the startup process.
LED Meaning
Green OK
OFF Failure of an on-board PSU, or there was a glitch on the 3.3V PSU (in which
case reseating the card may resolve the problem). In the first case, reseating
the card will not resolve the problem.
LED Meaning
Blinking red System OK (heartbeat signal)
LED Meaning
OFF No read/write operations in progress
Blinking green Read of write operation in progress
LED Meaning
Green Normal (the Kaleido-X software, XEdit, XAdmin are available)
Blinking orange Firmware initialization completed (waiting for the Kaleido-X
software to start)
Orange Transitory state during firmware initialization
Red Initial state
To Next Page
Loading...