31
Kaleido-MX (3RU)
Hardware Description & Installation Manual
The following table lists some (but not all) output formats supported at the HDMI
connections. You can customize your own timing rates for resolutions ranging from
1024
× 768 pixels up to 1920 × 1200 pixels (all progressive scan), by using XEdit.
Network Settings Panel
Kaleido-MX output cards are shipped with default network settings, which you must
replace with values suitable for your network environment. You may need to consult your
network administrator to get the correct values. Enter the appropriate IP address, mask and
gateway information to configure a Kaleido-MX output card within your Ethernet network.
Kaleido-MX HDMI output resolutions
Resolution Format name Refresh rates (Hz)
1024 × 768 XGA 50.00, 59.94
1280 × 720 Margay 50.00, 59.94
1280 × 768 WXGA 50.00, 59.94
1280 × 1024 SXGA 50.00, 59.94
1280 × 1024 BARCO 59.94
1360 × 768 NEC 50.00, 59.94
1480 × 1200 Christie 50.00, 59.94
1600 × 1200 UXGA 50.00, 59.94
1920 × 1080 Baycat 50.00, 59.94
1920 × 1200 WUXGA 50.00, 59.94
Note: All output cards within a Kaleido-MX frame must have their output
heads configured with the same refresh rate. If your frame is referenced, then
the heads’ refresh rate must also match the reference signal's refresh rate.
To Next Page
Loading...