32
Operation
Info Panel
Click Apply to set these values into the card, or Cancel to leave the original values
unchanged.
Info Panel
When a Kaleido-MX input or output card is included in an iControl environment, certain
information about the card may be made available to the iControl system. In the boxes with
a white background, you can type labels and comments that will make this card easier to
identify in a complex setup.
Notes
• These settings apply to the rear-panel Ethernet port of the Kaleido-MX
output cards; not to the Ethernet ports at the back of the Densité controller
card.
• On all Kaleido multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.
• The position of the output card is not configurable; the information is
presented here for information only.
• Quad-head Kaleido-MX systems, which include two output cards, require
three IP addresses: one for each output card, and a virtual IP address for the
system. A dual-head system requires only one IP address (the output card’s
IP address automatically doubles as the system IP address). Refer to the
Kaleido-MX (3RU) Quick Start Guide for detailed setup information.
To Next Page
Loading...