81
LDX 150
User Guide
3 The following appears in the viewfinder:
+
Note
+ ☞
Note
If you did not select one of the memory positions FL50, FL60, AW1 or AW2, a message (“Set
Color Temp”) appears in the viewfinder.
4 Point the camera so that the reference white surface is between the two small black
boxes.
5 On the CGA, tap the WHITE BALANCE button again.
On the camera, press the WHITE BALANCE button on the front panel again to start the
measurement procedure.
6 A message indicating that the process is running appears:
+
Note
+ ☞
Note
If there is insufficient light, the “light level too low” message appears in the viewfinder.
7 When the process is completed (within a few seconds) the OK message and the
measured color temperature appears in the viewfinder:
To Next Page
Loading...
