28 / 32
S3084_S3086_S3078_S3085_MP_V1
Disconnect the 3-wire connection cable of the speed controller from
the receiver. Connect the 2 wire end of the adapter cable (Item no.
7168.S) to the telemetry jack (see page 7) on the speed controller.
Now connect an operating battery (do not exceed the max. permis-
sible operating voltage!) to the appropriate connections on the con-
troller. However, do not yet switch on the controller by means of the
ON/OFF switch on the controller.
Then you have two possibilities to update the firmware: “Auto down-
load“ or “File download“.
If you wish to transfer the current firmware to the controller auto-
matically, use the "Load automatically" option.
The application will then attempt to download the current firmware
over the Internet.
Immediately after clicking on the button, the bar starts to become
green. Switch on the controller at the switch before the bar fills.
Another dialogue window opens in which you have to select the
desired firmware by clicking the “Open file” button. The application
then downloads the file and transfers it to the controller.
If you wish to transfer special firmware that you have in the form of
a file to the controller, use the "Open file" option. In then opened
dialogue window select the previously downloaded file, then the
green bar starts to fill. Switch on the controller at the switch before
the bar fills; the application will then transfer the firmware.
Detailed update instructions for HoTT components can be found on
our home page in the download section for the particular item.
To Next Page
Loading...
Need help?
General
