18 / 28
S1005_S1006_jp_V1
Adjusting the control stick
Both the left and right control sticks can optionally be set from
neutralizing to non-neutralizing and vice versa. The control
sticks' restoring force can also be adjusted.
The related adjusting system is on the back of the transmitter in
the battery compartment, under the rubber covers, and under
the side grips attached with double-sided adhesive tape. Make
the desired adjustment by turning the relevant setscrew using a
standard cross screwdriver.
1 and 2 / 9 and 10
Adjust the braking force with the outermost of the two screws,
and adjust the strength of the control stick ratchet using the
innermost screw.
4 and 5 / 7 and 8
Adjust the return force of the control direction by turning the rel-
evant setscrew using a standard cross screwdriver.
3 and 6
To change the standard setting of the control sticks, turn the
screw toward the inside of the transmitter until the relevant con-
trol stick can move freely from stop to stop, or turn it outward
until the control stick resets itself independently.
To Next Page
Loading...
