GRAUPNER Falcon 12

EN
No. S1019.AIR
No. S1034
No. S1035
No. 33579
No. 33583
Firmware V2 for 2,4 GHz HoTT receiver with 3-axis gyro (and vario)
Falcon 12 (plus), GR-18, GR-24 PRO
Manual
Copyright © Graupner/SJ GmbH

GRAUPNER Falcon 12 Specifications

General

Brand	GRAUPNER
Model	Falcon 12
Category	Receiver
Language	English

Summary

Technical Specifications

Safety Warnings and Symbol Guide

Symbol Descriptions and General Safety

Explains symbols and provides crucial safety guidelines for operation.

Receiver Installation Guide

Model Mounting Procedures

Instructions for mounting the receiver in fixed-wing and helicopter models.

Receiver Wiring and Power Supply

Component Connection and Power Input

Transmitter Binding Process

Receiver Reset and Gyro Initialization

Resetting Receiver and Initializing Gyro

Procedures for resetting the receiver and initializing the gyro system.

Fixed-Wing Model Configuration

Free Mixer Setup and Examples

Gyro Settings and Axis Assignment

Gyro Mode, Axis Sensitivity, and Factors

Gyro Axis Assignment Process

Servo Configuration and Axis Assignment Steps

Configuring servos and performing the gyro axis assignment procedure.

Servo Limit Adjustment Procedure

Helicopter Model Setup Guide

Mechanical Preparation and Transmitter Presets

Swashplate Settings for Helicopters

Swashplate Sensitivity, Rate, Expo, and PID Control

Adjusting swashplate sensitivity, rate, expo, and PID parameters.

Advanced Helicopter Expert Mode Settings

Direct Stick Response and PID Tuning

Tail Rotor Settings for Helicopters

Tail Rotor Sensitivity, Rate, Expo, and PID Control

Adjusting tail rotor sensitivity, rate, expo, and PID parameters.

Base Helicopter Setup Configuration

Rotor Direction, Swashplate Type, and Frequency

Setting rotor direction, swashplate type, and servo frequency.

Swashplate Direction and Alignment Trimming

Adjusting swashplate servo direction and performing alignment trimming.

Swashplate Cyclic Travel and Tail Servo Setup

Tail Rotor Frequency and Trim Adjustments

Gyro Axis Assignment and Verification

Gyro Axis Assignment Procedure and Checks

Step-by-step assignment and verification of gyro control axes.

Verifying Gyro Axis Functionality

Firmware Update Procedure

Firmware Update Warnings and Steps