14 / 52
S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
Binding
To establish a connection with the transmitter, the Graupner HoTT
receiver must first be "bound" to at least one model memory in "its"
Graupner HoTT transmitter. This process is generally called "bind-
ing". However, the method to be used is not always the same, which
is why the following step-by-step instructions apply only to binding
the specified receivers to any transmitter:
Receiver Falcon 12 (plus)
Binding step-by-step
• If the receiver is already bound to a specific transmitter and this
binding should be maintained, the transmitter should ideally be
switched on before the receiver. At the latest, however, within
approximately 15 seconds from the moment when the receiver
is switched on, the red LED of the receiver is constantly on.
Attention
As soon as the LED starts to flash, the receiver is in bind mode.
From this point on, there is a risk that the receiver inadvertently
binds to another HoTT transmitter, which also happens to be in
the bind mode at the same time and in the same place, where-
upon the model can run uncontrolled at any time.
• If the receiver is unbound or it should be bound to another trans-
mitter or only the model memory has to be changed than the
previous one, proceed as follows:
1. Prepare the transmitter or model memory to be bound accord-
ing to the instructions for binding.
2. Switch the receiver power supply on.
3. The LED of the receiver Falcon 12 (plus) HoTT lights up con-
stantly red.
4. Approximately 15 seconds after the receiver is switched on,
its red LED starts to flash, indicating that the receiver is now
in bind mode.
5. Start the transmitter-side binding according to the instruc-
tions of the transmitter.
6. If the red LED of the receiver goes out within about three sec-
onds, the binding process has been completed successfully.
7. Your transmitter/receiver combination is ready for operation.
8. If the LED on the receiver remains still red, the "binding" has
failed. Change the positions of the associated antennas and
try the entire procedure again.
To Next Page
Loading...
Need help?
General
