16 / 52
S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
Gyro initialization before starting the flight operation
Each time the receiver system is switched on, the gyro system and
possibly also the vario of the receiver require approx. 2 seconds for
initialization. During this period, the model must not be moved.
Initialization of the gyro step-by-step
1. Switch on transmitter.
2. Move or hold the sticks in neutral position.
3. Switch on the receiver system of the model.
The gyro immediately becomes active but still needs to be ini-
tialised.
4. Do not move the model.
5. After approx. 2 seconds in still position, the ailerons move briefly
in both directions.
These "wiggles" indicates that initialization has been successful.
6. The calibration is completed successfully.
The model can be moved.
Notes
• During initialization, the receiver determines the neutral posi-
tion, for this reason it is imperative that the model is not moved
during activation!
• During the gyro initialization also the central position of each
control channel is saved. By gyro suppression the gyro correc-
tion is reduced with increasing control deflection, at +/-100% of
the gyro is deactivated.
To Next Page
Loading...
Need help?
General
