15 / 52
S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
Receiver GR-18 HoTT and GR-24 PRO HoTT
Binding step-by-step
1. Prepare the transmitter to be bound according to its instructions
for binding.
2. Switch the receiver power supply on.
The LED of a receiver GR-18 HoTT or GR-24 PRO HoTT lights up
constantly red.
3. Push and hold for about three seconds the SET button on the
receiver.
4. Start the transmitter-side binding according to the instructions of
the transmitter:
ശ If the LED of the receiver GR-18 HoTT or GR-24 PRO HoTT
starts to light constantly green within approximately three
seconds, the binding process has been completed success-
fully.
The transmitter/receiver combination is ready for operation.
ശ If the LED of a receiver GR-18 HoTT or GR-24 PRO HoTT
remains solid red, the "bind" or "Binding" has failed. Change
the positions of the associated antennas and try the entire
procedure again.
Receiver reset
Reset the receiver settings step-by-step
1. As described in the submenu "Setting & data view" of the telem-
etry menu described below, in the line "Model Type" of the display
page "Receiver" switch from "Airplane" to "Heli", or vice versa.
2. Push or press the ENT key or equivalent.
3. Disconnect the power supply and reconnect it.
4. In the "Model type" line change the model type from "Heli" to
"Airplane", or vice versa.
5. Push or press the ENT key or equivalent.
6. Disconnect the power supply and reconnect it.
The receiver is reset to factory settings.
To Next Page
Loading...
