35 36
3) Motor test
- When to operate motor, you may check the average current (Aa) and the peak
current (Ap) in 6 steps
Test voltage setup. 4.8V or 7.2V
It shows the average current and the peak current of
6 steps
Every step is operated in 5sec on/ 3sec off
Setting the number of cycle, 1~10 cycles
Setting the operating voltage, operating time, delay time
for each 4 steps
The operating cycle number
Warmer setup
Connect warmer to 4mm banana charge socket and tap WAEMER icon to access warmer
setup mode This page is consisted of 2 menus
1) Battery Warmer
-
Lithium type batteries in low temperature tend not to output normally. This function is used
to warm battery to lead to output normally when to store batteries outdoor. Connect the
exclusive battery warmer bag to the charger output terminal and temperature sensor connector
then program the parameters to use
2) Tire Warmer
-
It is used to warm rubber tire and gives you an important competitive edge on the track
Connect the tire cup to the charger output terminal and to temperature connector then
program the parameters to use
Temperature setup
Alarm setup
Alarm rings on the preset time and the charger still keeps
operating. When to tap STOP button, alarm is stopped
Output voltage setup
It is controlled automatically when the temperature sensor
is installed and the preset voltage is outputted if there
isn’t temperature sensor.
The temperature setup range is 5~15V
Processing time and temperature
Temperature is not controlled automatically when to use a bag that isn’t equipped with
temperature sensor, so you need to control voltage to keep the desired temperature of a
bag inside. Please notice that over voltage setup causes a fire
To Next Page
Loading...
Need help?
General
