EN - 19
Proper maintenance can prolong the life of
unit. The following charts show the
recommended service schedule. More
frequent service may be required due to
extreme working conditions (heavy loads,
high ambient temperatures, dusty conditions,
or airborne debris).
See the maintenance instructions in the
Engine Manual for additional information.
MAINTENANCE SCHEDULE
WARNING: AVOID INJURY. Read
and understand entire Safety
section before proceeding.
Period Service Task
Each Use
Check Safety Interlock WARNING: Safety interlock system failure
and improper operation of unit can result in
death or serious injury. Test this system each
time the unit is operated. If this system does
not function as described, do not operate
until repairs are made. See Safety Interlock
System on page 12.
Check Parking Brake
Interlock System
See Parking Brake Interlock System on page 12.
Check Hydraulic Fluid Check hydraulic oil level mark on expansion tank. Add
15W-50 synthetic motor oil (Gravely p/n 00057100) or
equivalent as needed. Do not overfill. See Check
Hydraulic Fluid Level on page 22.
Check Tires See Specifications on page 38 for correct tire
pressure.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is possible
when they are serviced incorrectly:
• Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
• Do not inflate the tires above the recommended
pressure.
• Do not stand in front or over the tire assembly when
inflating. Use a clip-on chuck and extension hose
long enough to allow you to stand to one side.
Clean Unit Clean engine, battery, operator’s platform, mower
deck, etc. of dirt and debris. Do not use solvents, hard
cleaners, or abrasives.
NOTICE: Protect painted surfaces with automotive
type wax.
IMPORTANT: Do not spray the unit with water,
especially when the unit is warm from operation.
Water can seep into bearings and damage them.
Follow Engine Manual
Maintenance Schedule
Perform scheduled engine maintenance. Refer to
engine manual for detailed instructions.
Every 25
Hours
Check Mower Blades Check mower blades for wear. Sharpen or replace as
needed.
See Mower Blades on page 23.
Every 50
Hours
Check Air Filter Check air filter for dirt. Clean as required. Follow
Engine Manual for maintenance schedule.
Lubricate Unit Oil all pivot points and pin connections. Grease lube
fittings.
Check Parking Brake Adjust if necessary. See Parking Brake Adjustment on
page 27.