Gravity Measurement CWT7 - Speed Setting; Zero Tracking

CWT7 USER AND SERVICE MANUAL
Revision: 03/2018 Page: 9
UF- 7 Speed setting (*)
Modes: spEED1: Standard speed
spEED2: High speed
spEED3: Low speed
1. Press the key to enter.
2. Press the key to select the desired mode.
3. Press the key to confirm.
UF- 8 Zero tracking(*)
Modes: Zp 0 : OFF
Z p 1 : One division tracking at zero
Z p 2 : Two division tracking at zero
Z p 3 : Three division tracking at zero
Z p 4 : Four division tracking at zero
Z p 5 : Five division tracking at zero
1. Press the key to enter.
2. Press the key to select the desired mode.
3. Press the key to confirm.
UF- 9 G Value setting
1. Press the key to display the G value of manufacture place.
2. If set the G value of local press the key and then press the or
key and key to input the new G value.
3. Press the key to confirm.