CWT7 USER AND SERVICE MANUAL
Revision: 03/2018 Page: 3
What Is Inside Box
AC/DC adaptor (110V)
CWT7 weighing scale, with adhesive film covered platter. Two parts are separated to protect
the load cell during transportation.
Rechargeable battery is installed inside the scale.
Two wire seals. The wire seal is used usually by the inspector of Department of Weight and
Measure or authorized dealer. The wire seal is threaded through a metal rode that protrudes
through the bottom of the device and through a hole in the scale base adjacent to the metal
rode.
Set up the Scale
Place the scale on a stable, level surface out of the way of air currents. The scale must
be level during use. Adjust the feet and use the integrated bubble at the front of the
scale to achieve level. Be sure that scale does not rock back and forth. Ensure no
weight is on the pan when turning on the scale. Scale is operated using the
rechargeable battery or AC adaptor. is used to charge the battery, and scale can
operate without DC adaptor.
LCD Display
Size: 130 mm x 46 mm X 2.8 mm
Font height: 30 mm
Segments: 6 or 7??
To Next Page
Loading...
