GRAVOGRAPH L-SOLUTION 100 Ex Fibre User Manual

Before installing and using this machine, you must read this user guide carefully.
Keep it in a safe place, in case you need to refer to it later.
G2142 701 - 04.2011 - ENG - (UPDATED EDITION NUMBER : 1)
User manual
L-SOLUTION 100 Ex
Machine
LASER engraving machine
First contact
L-SOLUTION 100 Ex YAG

GRAVOGRAPH L-SOLUTION 100 Ex Fibre Specifications

General

Brand	GRAVOGRAPH
Model	L-SOLUTION 100 Ex Fibre
Category	Engraver
Language	English

Summary

Regulatory Information

Compliance Standards

Details the EC and EEC directives the hardware is designed to comply with.

Safety and EMC Standards

Covers electrical safety, machine safety, and electromagnetic compatibility standards.

Warning Labels and Disposal Guidelines

Explains safety warning labels and proper disposal of electronic equipment.

Overview

Essential Safety Contra-indications

Lists critical warnings and precautions for safe operation and use.

Installation

Physical and Environmental Placement

Recommendations for machine placement, stability, clearance, and ventilation.

System Connections and Requirements

Electrical Installation Procedures

Covers electrical requirements, plug connections, and avoiding interference.

Initial Power-up and Troubleshooting

Explains how to power on/off the machine and common initial problems.

PC Connectivity Setup

Connection Cable Types

USB Connectivity Procedure

Step-by-step guide for connecting the machine to a PC via USB.

Parallel Connectivity Procedure

Step-by-step guide for connecting the machine to a PC via parallel port.

Laser Printer Driver

Driver Overview and System Requirements

Machine Preparation and Driver Installation

LASER Settings and Graphics Configuration

Details the LASER settings tab for graphics, colors, plate, and orientation.

Engraving Parameter Tuning

Running the Machine Step by Step

System Power-up and Graphic Transfer

Guides on powering on the system and transferring graphics from the PC.

Material Positioning and Laser Focusing

Instructions for placing material and adjusting the laser beam focus.

Initiating and Monitoring Engraving Process

Steps to start the engraving process and monitor for potential issues.

General Maintenance

Maintenance Guidelines and Supplies

System Cleaning Procedures

Optics Cleaning and Inspection

Procedures for cleaning and inspecting mirrors, beam window, and focus lens.