Need help?Do you have a question about the GRAVOGRAPH LS900 XP and is the answer not in the manual?
General| Laser Source | CO2 laser |
|---|---|
| Resolution | up to 1200 dpi |
| Connectivity | USB, Ethernet |
| Software | Gravostyle |
| Power Supply | 230V / 50-60Hz |
| Engraving Area | 24 x 24 in (610 x 610 mm) |
| Engraving Speed | Up to 1000 mm/s |
Overview of the Gravograph LS900 series laser engraving and cutting machines.
Details crucial safety instructions for operating the water chiller for ENERGY machines.
Covers general recommendations and safety regarding laser devices and personnel safety.
Explains safety considerations and requirements when using the optional Class 4 Passthrough feature.
Details safety instructions and regulations for personnel entering a restricted laser controlled zone.
Provides general instructions to avoid laser radiation exposure and emphasizes wearing safety glasses when required.
Outlines safety precautions for handling and cleaning optical components like mirrors and lenses.
Discusses potential hazards from fumes and toxic particles emitted by certain materials during laser marking.
Details safety precautions related to the high voltage supply used in ENERGY machines.
Covers placement, stability, ventilation, temperature, and workspace arrangement for machine installation.
Explains the importance and installation of an air extraction system for fume and particle removal.
Guides users on connecting water hoses to the chiller and machine, and securing them with hose clamps.
Instructs on filling the water chiller tank with demineralised water and checking connections and the drain plug.
Covers electrical connection requirements, grounding, interference avoidance, and cable management.
Explains how to connect the power supply to the water chiller and switch it on, with safety checks.
Guides on connecting the machine's power cable and extraction system link cable, with emphasis on screw tightening.
Details how to configure and use the PLC function, including available inputs, outputs, and their characteristics.
Guides on the correct sequence for switching on the chiller and machine, and checks before operation.
Identifies and describes the function of each button and indicator on the machine's control panel.
Details the specific functions associated with each button on the machine's control panel.
Describes the temperature alarm function, error codes (E1-E5), and how to stop audible alarms.
Explains automatic focus adjustment using autofocus and how to enable/disable it via the driver or button.
Outlines steps for starting engraving, including air extraction, object check, focus, and door closure.
Emphasizes unplugging the machine before cleaning and the importance of regular cleaning for optimal operation.
Guides on inspecting and cleaning mirrors and lenses, warning against touching optics or removing them.
Details the step-by-step process for adjusting the autofocus using the machine interface and adjustment gage.
Instructs on placing the autofocus adjustment gage and checking its movement with the lens support.
Guides on removing the gage, closing the door, and initiating the autofocus sequence via the control panel.
Explains how to set the machine's origin point (0,0) by positioning a plate and using the laser pointer.
To Next Page
