GRAVOGRAPH LS900 XP - Starting Engraving Process Steps

58
M_LS900 XP IQ Energy_EN_B
Using the machine
7. Start-up engraving
1. Switch on the air extraction system.
2. Select one of the 2 modes (See: Air extraction system (optional)).
3.Checkthattheobjectiscorrectlypositionedintheengravingarea.
4. Check the focus.
5. Check that the door is closed.
6.Checkthatthescreenisdisplayingthe󰄈lename.
7. Press the key. (Control panel).
8. Removing and reloading material
Thelaserbeamisshuto󰘯oncethemachinehas󰘰nishedprocessingthematerial.Theheadgoesbacktothe
origin (top left corner).
Beforeopeningthedoor,waitafewsecondsforanyremainingfumesemittedduringthemarkingorcutting
process to be removed by the extraction system. In the L-Solution driver, it is possible to enter a timeout value
tosetadelaybeforetheairextractionsystemstopswhenmarkingis󰘰nished.
Open the upper door Remove the material.
Loadthenextmaterial.Ifitisthesamematerialastheonebeforeandthesame󰘰leisbeingexecuted,close
thedoor.Start-upengraving:Pressthekey.