GREE DC INVERTER HEAT PUMP CONDENSING UNIT
85
NOTE: Before removing the front panel, make sure power is cut off.
2. Remove the front plate.
Unscrew the screws of the
front plate with a
screwdriver.
3. Remove the front grill.
Unscrew the screws of the
front grill with a screwdriver.
4. Remove the front panel.
Unscrew the screws that
connect the front panel to
the middle insulating board
and screws around the front
panel.
5. Install the front panel.
Install the front panel by
mounting on 6 clasps on its
both sides. Please note that
there is one screw on the
lower right side.
To Next Page
Loading...
