Gree FLEXX60HP230V1AO - Page 92

GREE DC INVERTER HEAT PUMP CONDENSING UNIT
89
Disassembly of compressor
NOTE:Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step
Picture
Work instruction
4. Remove the compressor
from the chassis.
 Take out the compressor
and replace it.
NOTE:When replacing the
compressor, avoid touching
the nearby pipeline and
components.
5. Fix the new compressor back
onto the chassis.
 After replacing the
compressor, tighten up the
screws at the foot of
compressor.
6. Connect the compressor
suction port and exhause
port with the pipes.
 Weld the compressor
connection pipes and
connect them to the
compressor.
NOTE: When replacing the
compressor, avoid touching
the nearby pipeline and
components.